Laser marking machine
How to maintain the optical fiber laser marking machine?
2022-11-07 10:10:35 technical college

The daily maintenance of the optical fiber laser marking machine will not only improve the working efficiency of the laser marking system, but also extend the service life of the optical fiber laser engraving machine.
1. If the optical fiber laser marking machine cannot work normally, please cut off the power supply of the laser marking machine and the computer, and close the objective lens cover to prevent dust from polluting the optical lens.
2. When the machine is working, the circuit is in high voltage state. For non professionals, please do not carry out maintenance during startup to avoid electric shock.
3. If any fault occurs to the machine, please turn off the power immediately.
4. If the equipment is used for a long time, the dust in the air will be absorbed on the lower surface of the focusing lens. The lighter will reduce the laser power and affect the marking effect; Heavier lenses can cause the optical lens to overheat and burst. When the marking effect is not good, please carefully check whether the surface of the focusing lens is polluted.
5. If the surface of the focusing lens is polluted, please remove the focusing lens and clean its lower surface.
6. When removing the focusing mirror, be careful not to damage or drop the focusing mirror, or touch the surface of the focusing mirror with hands or other objects.
7. The cleaning method is to mix anhydrous ethanol (analytical grade) and ether (analytical grade) in a ratio of 3:1, and then infiltrate the mixture with a long fiber cotton swab or mirror paper, and then gently scrub the focusing lens. The used cotton swab or lens paper must be replaced once.
8. During the operation of the marking machine, do not move the laser marking machine to avoid damaging the machine.
9. Do not cover the stacker or put other objects on the optical fiber laser marking machine, so as not to affect the heat dissipation effect of the machine.
Tips:
1. Please do not touch the beam when the light pen of the laser marking machine is in operation.
2. The optical fiber laser light source is the core of the laser marking machine and must be moved carefully to avoid improper movement of the moving crusher.
3. During operation, once a fault is found, stop the operation immediately to avoid casualties.
4. The laser marking machine cannot be started at the wrong water cycle time.
5. When preparing to close the mark, a current of about 5A should be set.
6. Keep the outer surface clean and tidy.
7. In order to keep the circulating water of the internal optical fiber laser marking machine clean, please clean the water tank regularly and exchange clean deionized water.

Hot keywords

Redsail Tech Co. © 2002-2022. All Rights Reserved.

Contact us