In summer, the temperature rises everywhere, and many laser equipment will generate heat during use, resulting in some failures. Therefore, in order to avoid the failure of the laser cutting machine in summer, we must pay attention to the maintenance and repair of the laser cutting machine, so as to extend the service life of the machine.
With the arrival of July, the weather is getting hotter and the temperature is also rising. In the coming hot summer, Junyi laser gives warm tips that heatstroke prevention measures should be done well, whether it is going out to play or working outdoors. We should not only prepare for heatstroke prevention, but also maintain the laser cutting machine to prevent "heatstroke"
water-cooling
In high-temperature weather, the deterioration rate of cooling water will also accelerate. It is recommended that users of laser cutting machines use regular distilled water or pure water, and regularly clean the scale, so as not to cause scale in the laser and pipes to affect the laser power; Note that the cooling water temperature should not be too different from the air temperature. With the increasing temperature in summer, the working pressure of the cooling system of the laser cutting machine increases sharply. It is recommended to check and maintain the internal pressure of the cooling machine before the high temperature comes, and adjust it in time to adapt to the high temperature weather.
lubrication
Each guide rail should be cleaned frequently to remove dust and other debris to ensure the normal operation of the laser equipment. The rack should be cleaned frequently and lubricated. The time should be adjusted to shorten the time by 0.5-1 times compared with that in spring and autumn, and the oil quality should be observed. For machinery working in high-temperature areas, the viscosity grade of engine oil should be properly increased, the temperature of lipid oil is easy to change, and oil should be properly added to ensure lubrication without sundries. Carefully check the straightness of the cutting table of the laser cutting machine, the track and the verticality of the machine, and timely maintain and debug any abnormality found. The guide rail should be cleaned and lubricated frequently, and the motor should also be cleaned and lubricated regularly to keep the machine in the best state at all times. The machine can move better and cut more accurately during operation, and the quality of the cut products will be higher.
line
Check and replace aging wires, plugs, hoses and connectors; Check whether the pins and wires of the connectors of various electrical components are loose and tighten them in time to avoid burning out of electrical appliances and unstable signal transmission due to poor contact.
reminder
The summer sun, like a big stove, scorches the earth, even the air is hot, and people sweat all over when they move.
Note: be careful of frosting of the laser machine. Because of the large difference between the temperature of the water cooler and the ambient temperature, the laser and the cutting head will be frosted, which will cause damage to the equipment and lenses. Please increase the temperature of the water cooler. If not, please contact the after-sales service department in time to ask how to adjust it.
Remind you again of the temperature setting:
① Summer: low temperature 29, high temperature 30,
② Non summer: low temperature 25, high temperature 30,
For 1500s and 2000s models:
① Summer: low temperature 27, high temperature 30,
② Non summer: low temperature 25, high temperature 30,
Customers are advised to use air-conditioned rooms if conditions permit: set to 28 degrees dehumidification.
Sharpening knives does not miss firewood choppers, and even the most powerful machines need maintenance. Therefore, when the hot summer comes, protect your "love machine" and always be in the best state, so as to bring you greater benefits.