The water cooling unit of the laser cutting machine must be regularly maintained and maintained so as to ensure that the machine operates in good condition. In case of failure, remember not to deal with it without authorization. Professional technicians should be invited to repair it, and the machine should not be disassembled.
The following aspects shall be paid attention to in the daily maintenance of the water cooling unit of the laser cutting machine:
1. Regularly clean the fins. The cleaning method is: carefully brush the fins with a brush, and then blow them clean with compressed air. If necessary, clean and rinse them with water mixed with special air conditioner fin cleaner.
2. Dust the condenser regularly (the method is the same as above).
3. Regularly check the water level in the water tank of the chiller. If the water level is too low, add purified water or deionized water in time.
4. Regularly check the wiring terminals of electrical appliances and remove dust (after power off).
5. Regularly check whether the joints in the water system are leaking and whether the pipeline is aging. If there is any leakage, replace the relevant components in time. Laser cutting machine
6. Regularly check the water quality in the water tank of the water chiller. If the water quality of the cooling water becomes poor, turbid and the transparency decreases, all the deteriorated cooling water shall be drained in time and replaced with new cooling water.
7. Regularly clean the impurities on the filter element. If the filter element is damaged, it should be replaced in time. The replaced filter element must be the standard filter element required by the manufacturer.