When using the fiber laser cutting machine, we will do everything possible to reduce its loss on the premise of ensuring its cutting quality. What is the way to reduce its loss?
Before starting the optical fiber laser cutting machine, push the beam forward and backward by hand, and the trolley can only be powered on when there is no abnormal sound when it moves left and right. When completing the work of the day, the waste and debris in the machine should be carefully cleaned, so that the machine motion system can be protected from damage caused by foreign objects. Clean its moving parts to keep the machine in good working condition. The specific methods are as follows:
1. Inject a little lubricating oil into the screws, including the screws on the laser tube support and the first reflector, to facilitate disassembly and assembly during maintenance. Note: do not add lubricating oil to the synchronous belt, drag chain, air pipe, motor, sensor, lens and wire.
2. Do not place objects in the machine to avoid unnecessary damage to the machine.
3. Use cotton cloth to clean the dust and foreign matters on the metal oil tanker, metal shaft, sliding block and linear guide rail, then add lubricating oil, and carry out the reciprocating movement of empty line. The working mode of fiber laser cutting machine is mainly cutting, which is applied to metal cutting. The laser beam diameter of the laser cutting machine can reach 0.1mm, and the cutting diameter on metal materials can reach about 0.2mm. Therefore, the cutting pattern is very accurate. It not only improves the artistic taste and technical content of sheet metal processing, but also improves the profit space. Therefore, when operating the fiber laser cutting machine, we must cherish and standardize the operation, so that the equipment can better serve you.