1. Follow the general cutting machine operation specification process. Start the laser in strict accordance with the laser starting procedure.
2. The operator must be trained, familiar with the structure and performance of the equipment, and master the relevant knowledge of the operating system.
3. Wear labor protection articles as required, and wear qualified glasses near the laser beam.
4. Do not process a material until you know whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and steam.
5. When the equipment is started, the operator shall not leave the post without authorization or entrust someone to take care of it. If it is really necessary to leave, the machine shall be shut down or the power switch shall be cut off.
6. Keep the fire extinguisher within easy reach; Turn off the laser or shutter when not processing; Do not place paper, cloth or other inflammables near unprotected laser beams.
7. In case of any abnormality during processing, stop the machine in time to remove the fault or report to the supervisor.
8. Keep the laser, bed and surrounding areas clean and orderly, and stack workpieces, plates and waste materials as required.
9. When using gas cylinders, be careful not to crush the welding wires to avoid leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder supervision regulations. Do not expose the gas cylinder to the sun or close to the heat source. When opening the bottle valve, the operator should stand on the side of the bottle mouth.
10. High voltage standard process shall be followed during maintenance. Every 40 hours of operation or weekly maintenance, every 1000 hours of operation or every six months of maintenance should be carried out in accordance with the regulations and procedures.
11. After starting the machine, manually start the machine tool in the X and Y directions at low speed to check whether there is any abnormality.
12. After inputting the new workpiece program, you should first try to run it and check its operation.
13. When working, pay attention to the operation of the machine tool to avoid accidents caused by the cutting machine going out of the specified travel range or the collision between the two machines.