On the layout drawing, users can check the information of relevant site size and space requirements, including the installation size of equipment, the placement of control cabinets and water tanks;
The ground of the installation site shall be as flat as possible, and the unevenness of the installation range of the machine tool (the difference between the highest point and the lowest point is 8mm); The machine tool must be located on the same continuous and flat ground, the new ground must be completely dry, and the thickness of the concrete ground must exceed 20cm;
Foundation amplitude: less than 50um; Vibration acceleration: less than 0.05g. Avoid a large number of stamping and other machine tools nearby; If there is a punching machine tool, the foundation must be made of shockproof ditch, which is not less than 50cm wide and 100cm deep, and filled with energy absorbing substances such as {cinder, lime, sand, gravel, etc.
Laser cutting machine
The equipment space is required to be smoke-free and dust-free to avoid working environment with serious dust such as metal polishing and grinding;
The temperature of the power control cabinet is required to be 10 to 30 degrees Celsius, and the humidity is less than 70%. If it cannot be reached, air conditioning needs to be installed;
After the plant layout is confirmed, clarify the dust removal direction of the machine tool. If the dust remover is placed outdoors but should not be too far away from the machine tool, it is recommended to be less than 5 meters to avoid affecting the dust removal effect.
It is required to leave enough space on the right or left side of the machine tool to facilitate the entry and exit of the slag truck {if the customer has no special requirements, the length on the right side of the machine tool is determined by the size of the machine tool