At present, the plate tube integrated fiber laser cutting machine on the market is mainly for the cutting of thin metal plates. Cutting thin plates below 16mm is very convenient and fast, while the efficiency of cutting thick plates is relatively low, which is limited by the power of fiber lasers. Of course, science and technology are constantly developing. I believe we will soon see the high-tech board tube integrated optical fiber laser cutting machine.
Many customers will cause the failure of the board and tube integrated optical fiber laser cutting machine due to improper operation or other reasons during the use of the board and tube integrated optical fiber laser cutting machine. Although the failure is small, it is precisely because this small failure will delay the production and even cause losses, so how to timely save these failures and reduce losses is what we are about to know:
1、 When the start button is activated, the board tube integrated optical fiber laser cutting machine does not operate. At this time, we need to
1. Check whether the board tube integrated optical fiber laser cutting machine is powered on. If not, please plug in the power first.
2. Whether the main board parameters of the board pipe integrated optical fiber laser cutting machine are correct. If not, please refer to the software instructions to correct the parameters.
2、 There is no laser in the operation of the board tube integrated optical fiber laser cutting machine
1. Check whether the optical path of the board tube integrated optical fiber laser cutter is offset, and adjust it according to the optical path.
2. There is a problem with the circuit. At this time, the spot line of the integrated optical fiber laser cutting machine with the board and tube can be inserted into the signal terminal of the power supply for judgment.
3、 The laser is intermittent during operation
1. Check whether the water circulation of the board pipe integrated optical fiber laser cutting machine is smooth. If not, please clean the water tank and pump and dredge the water pipe.
2. Check whether the power supply voltage is stable at this time. If the voltage of the board tube integrated optical fiber laser cutting machine is unstable for a long time, please add a regulator to the power supply.
4、 The board tube integrated optical fiber laser cutting machine cannot process online data
1. Check whether the communication data line of the board tube integrated optical fiber laser cutting machine is connected well. If not, please shut down and reconnect the data line.
2. Whether the software USB is successfully installed. If the installation fails, please reinstall the software and USB driver.