In the operation of laser cutting machine, whether it is production or processing, safety is the first. Especially in the operation of metal laser cutting machine, once an accident occurs, whether it is personnel safety, equipment, or processing, one party will always be affected.
Ten safety points for operating laser cutting machine:
1. Operators must be trained to be familiar with the structure and performance of the equipment and master the knowledge of the operating system.
2. Please do not handle the materials that can be irradiated or heated by laser before identifying them, so as to avoid the potential hazards of smoke and steam.
3. When starting the equipment, the operator shall not leave the platform or look after it without authorization. If it is necessary to leave, stop the machine or cut off the power switch.
4. Meet the safety performance standard of general cutting machine. Start the laser in strict accordance with the laser starting procedure.
Laser cutting machine
5. Put the fire extinguisher in an accessible place. Please turn off the laser or shutter when it is not working. Do not put paper, cloth or other flammable materials near the unprotected laser beam.
6. Do not handle materials that can be irradiated or heated by laser before they are identified, so as to avoid the potential danger of smoke and vapor.
7. If any abnormality is found during the processing, the machine should be shut down immediately, and the fault should be eliminated or reported to the supervisor in time.
8. Wear occupational protective equipment as required, and wear compatible laser goggles near the laser beam.
9. When using gas cylinders, avoid crushing the welding wire to avoid leakage accidents. The use and transportation of gas cylinders must comply with the regulations on gas cylinder supervision. It is forbidden to explode the gas cylinder in the sun or near the heat source. When opening the bottle valve, the operator should stand beside the bottle mouth.
10. Please observe the high voltage safety regulations during maintenance. Carry out maintenance according to standards and procedures, and check whether there are abnormalities.