Through the recent market survey and return visit, we found that many customers do not know much about the aging problems of laser cutting machines, and do not know how to deal with them. They have consulted us many times. Then, how to slow down the aging of laser cutting machines?
1. Selection and maintenance of laser
Laser is the primary component of laser cutting machine. Its quality directly affects the performance of metal laser cutting machine. If its quality itself has problems, it will accelerate the rapid aging of metal laser cutting machine.
In addition, the later maintenance work is also very important. After the laser works for a period of time, its power will inevitably decline. Therefore, doing a good job in the maintenance of the laser at ordinary times can try to keep the laser function at a standard and delay the aging of the laser.
2. Operating environment of laser cutting machine
The laser cutting machine has certain requirements for the temperature of the working room. If its temperature is too high, it will cause a crash and slow response. If the temperature is too low, it will cause damage to the gas pipe and cable, which is easy to break and leak. Therefore, controlling the working environment temperature of metal laser cutting machine is one of the key factors to delay aging.
In addition, the metal laser cutting machine will produce a lot of metal dust in operation. However, these dust, as well as dust and smoke in the air, will attach to the equipment, which will increase the intensity of wear between various parts of the equipment. At the same time, the attached dust will also affect the light transmittance of the focusing lens, indirectly affecting the cutting accuracy of the metal laser cutting machine.
The aging of laser cutting machine is an irresistible trend. How to protect and delay the aging is the key problem. We hope users can do a good job of maintenance in their daily work. In addition, if there are any problems in the work of the equipment, they must not be ignored, and they must be handled in time to keep the equipment in good condition.