Laser Engraving Machines
Precautions for the use of acrylic laser engraving machine
2022-04-29 14:37:55 technical college

Acrylic laser engraving machine uses the heat energy of laser to engrave materials. The laser in acrylic laser engraving machine is its core. Generally speaking, acrylic laser engraving machine is more widely used, with higher engraving accuracy and faster engraving speed. Moreover, compared with the traditional manual carving method, acrylic laser carving can also make the carving effect very delicate, which is no less than the craft level of manual carving. It is precisely because the laser engraving machine has so many advantages that the application of acrylic laser engraving machine has gradually replaced the traditional engraving equipment and methods and become the main engraving equipment.

 

Acrylic laser engraving machine

 

Today, let's take a look at our minteying acrylic laser engraving machine. What should we pay attention to in the process of use?

 

1. The installation fulcrum of the laser tube should be reasonable, and the fulcrum should be at 1 / 4 of the total length of the laser tube, otherwise the spot mode of the laser tube will deteriorate, and some spots will become several points after working for a period of time, resulting in the decline of laser power and failure to meet the requirements, resulting in continuous tube replacement.

 

2. The cooling system shall be grounded, the water tank and water circuit shall be cleaned frequently, and the temperature control point of the refrigeration temperature control water tank shall be reasonable, otherwise the laser tube is easy to be damaged, the condensation power is reduced, the cold water head of the tube falls off, the service life is greatly shortened, and sometimes it cannot work, resulting in continuous tube replacement.

 

3. The water protection shall be checked and cleaned frequently. The cooling water cannot be flushed frequently. The water protection float switch or the water protection float switch does not reset, and the short-circuit method cannot be used to solve the urgent problem. The cooling water quality is good, and the aluminum oxide of the water nozzle is too serious. After use for a period of time, the dirt in the water pump, water pipe and water protection should be cleaned regularly, otherwise the laser tube will burst or the cold water head will fall off.

 

4. The air suction device shall be checked and cleaned regularly to clean the air duct of the fan Otherwise, a lot of smoke and dust can not be discharged, which will seriously and quickly pollute the lens and laser tube, making all mechanical and electronic components easy to oxidize, resulting in poor contact.

Hot keywords

Redsail Tech Co. © 2002-2022. All Rights Reserved.

Contact us