Laser Cutting Machines
Operation specification of laser cutting machine
2022-04-29 14:22:32 technical college

       1. Observe the safety operation regulations of general cutting machine. Start the laser in strict accordance with the laser starting procedure.

 

  2. Operators must be trained, familiar with equipment structure and performance, and master relevant knowledge of operating system.

 

  3. Wear labor protection articles as required, and wear protective glasses that meet the requirements near the laser beam.

 

  4. Do not process a material until you know whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and vapor.

 

  5. When the equipment is started, the operator shall not leave the post or entrust someone to take care of it without authorization. If it is really necessary to leave, stop the machine or cut off the power switch.

 

  6. Keep the fire extinguisher within easy reach; Turn off the laser or shutter when not processing; Do not place paper, cloth or other inflammables near unprotected laser beams.

 

  7. In case of any abnormality during processing, stop the machine immediately, eliminate the fault in time or report to the supervisor.

 

  8. Keep the laser, bed and surrounding site clean, orderly and free of oil stain, and stack workpieces, plates and wastes according to regulations.

 

  9. When using gas cylinders, avoid crushing welding wires to avoid electric leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder supervision regulations. Do not expose the gas cylinder to the sun or close to the heat source. When the bottle mouth is opened, the operator must stand on the side of the bottle mouth.

 

  10. High voltage safety regulations shall be observed during maintenance. Maintenance shall be carried out every 40 hours of operation or every week, every 1000 hours of operation or every six months in accordance with regulations and procedures.

 

  11. After startup, manually start the machine tool in the X and Y directions at low speed to check whether there is any abnormality.

 

  12. After inputting the new workpiece program, it shall be tested and checked for operation.

 

  13. When working, pay attention to the operation of the machine tool to avoid accidents caused by the cutting machine out of the effective travel range or the collision between the two machines.

 

   a laser cutting machine has tens of thousands or even hundreds of thousands of pieces of equipment, so we must pay attention to it in operation, and pay attention to maintenance and maintenance in order to increase the service life of the equipment, save costs and create greater benefits.

Hot keywords

Redsail Tech Co. © 2002-2022. All Rights Reserved.

Contact us