1. Observe the general cutting machine safety operating procedures. Start the laser in strict accordance with the laser start-up procedures.

2. The operator must be trained, familiar with the structure and performance of the equipment, and master the knowledge of the operating system.

3. According to the provisions of the wear good labor protective equipment, in the vicinity of the laser beam must be worn in line with the provisions of the protective glasses.

4. In the absence of clear whether a material can be irradiated or heated by laser, do not process it, so as to avoid the potential danger of smoke and vapor.

5. equipment start operators shall not leave their posts or trustees to be managed, such as indeed need to leave should be shut down or cut off the power switch.

6. To put the fire extinguisher within reach; not processed to turn off the laser or light gate; do not place paper, cloth or other flammable materials near the unprotected laser beam.

7. In the process of abnormalities found in the process, should immediately stop, timely troubleshooting or report to the competent personnel.

8. Keep the laser, the bed and the surrounding site is clean, orderly, no oil, workpiece, plate, waste materials in accordance with the provisions of the stacking.

9. When using gas cylinders, should avoid crushing welding wires to avoid leakage accidents. The use of gas cylinders, transportation should comply with the gas cylinder monitoring procedures. Prohibit gas cylinders in the sun or near the heat source. When opening the bottle valve, the operator must stand on the side of the bottle mouth.

10. Observe the high-pressure safety regulations during maintenance. Every 40 hours of operation or weekly maintenance, every 1,000 hours of operation or every six months maintenance, in accordance with the provisions and procedures.

11．The machine should be started manually at low speed in X and Y directions after powering on the machine to check and confirm that there are no abnormalities.

12. After the new workpiece program input, should be a test run, and check its operation.

13 work, pay attention to observe the operation of the machine tool, so as to avoid the cutting machine out of the effective range of travel or two collision caused by accidents.

Laser cutting machine a device tens of thousands of dollars or even hundreds of thousands of dollars, so in the operation must pay attention to, and usually pay attention to the maintenance and maintenance in order to increase the service life of the equipment, cost savings, to create greater benefits.