1、 Comply with general cutting machine safety operating procedures. Strictly follow the laser startup program to start the laser.

2、 The operator must undergo training, be familiar with the equipment structure and performance, and master relevant knowledge of the operating system.

3、 Wear labor protective equipment according to regulations, and wear protective glasses that meet regulations near the laser beam.

4、 Do not process a material until it is clear whether it can be irradiated or heated by laser, to avoid the potential danger of smoke and vapor generation.

5、 When the equipment is in operation, operators are not allowed to leave their positions or entrust someone to take care of them without authorization. If it is indeed necessary to leave, the machine should be shut down or the power switch should be cut off.

6、 Keep the fire extinguisher within easy reach; Turn off the laser or shutter when not processing; Do not place paper, cloth, or other flammable materials near unprotected laser beams.

7、 When any abnormalities are found during the processing, the machine should be immediately shut down, the faults should be promptly eliminated or reported to the supervisor.

8、 Keep the laser, bed, and surrounding area clean, orderly, and free of oil stains, and stack workpieces, boards, and waste materials according to regulations.

9、 When using gas cylinders, it is important to avoid damaging the welding wires to prevent leakage accidents. The use and transportation of gas cylinders should comply with the gas cylinder supervision regulations. Do not expose gas cylinders to direct sunlight or close to heat sources. When opening the bottle valve, the operator must stand on the side of the bottle nozzle.

10、 Observe high-voltage safety regulations during maintenance. Follow regulations and procedures for maintenance every 40 hours of operation or every week, every 1000 hours of operation or every six months.

11、 After starting the machine, the machine should be manually started at low speed in the X and Y directions to check and confirm if there are any abnormalities.

12、 After inputting the new workpiece program, it should be tested first and its operation should be checked.

13、 When working, pay attention to observing the operation of the machine tool to avoid accidents caused by the cutting machine going out of the effective travel range or collision between the two machines.

A laser cutting machine has tens of thousands or even hundreds of thousands of pieces of equipment, so it is necessary to pay attention during operation, and to pay attention to maintenance and upkeep in order to increase the service life of the equipment, save costs, and create greater benefits.