1. Can the laser head collision machine be restricted?

The origin switch is broken or not set on the panel.

2. Cutting without sealing?

Belt adjustment and parameter settings.

3. Is the cutting machine pre adjusted to have light or no light during processing?

It's a control card issue

4. Inconsistent cutting dimensions?

Improper adjustment of wheelbase and pulse

5. When working, does a complete curve have a short distance without cutting, also known as bouncing light?

It is caused by the looseness of the sliding blocks of the crane during long-term high-speed operation, which can be solved by simply adjusting the sliding blocks on both sides of the crane.

6. In the same version, some areas are continuously cut, while others are continuously cut?

Due to deviation or unevenness of the workbench, it is necessary to adjust the platform surface. Sometimes it is caused by deformation of the guide rail, and when it is necessary to adjust the guide rail.

When cutting, sometimes the two ends cut each other or sometimes separate?

If the fixing screw of the synchronous wheel is loose or there is a problem with the motor wire, it is best to replace one set instead of one or two separately.

8. Is the chiller prone to high temperature alarms in summer?

The weather is too hot, and the cooler has poor heat dissipation or insufficient cooling capacity. Self made chillers will not have the problem of insufficient cooling capacity. Generally speaking, if the radiator is too dirty and the ventilation is good, it can cause an alarm. Small chillers generally have insufficient cooling capacity, and temperature differences can be adjusted to appropriately increase the alarm temperature to solve the problem.

9. Does not emit light when emitting light?

First, the temperature of the open signal is unstable, including the light signal and the water chiller signal, then check whether the potentiometer is in poor contact, and finally check whether the power supply is broken.

10. Do not move when driving without returning to the original point?

All car motors are not powered on, and the laser head is easily pushed by hand when starting. The cause of the malfunction is damage or self-protection when the power is turned on. You can turn off the power supply for ten minutes before starting and replace the switch power supply.

How many minutes after cutting the laser tube, does the light weaken?

There are three possibilities: there is a power problem, the laser tube is broken, and the output frequency of the laser tube in the software is incorrect.

12. Does the cart often shake violently when moving?

If there is a problem with the servo limit line or limit, changing the line or limit can solve the problem.