What are the precautions for using a fiber laser cutting machine?

1. Wear labor protective equipment according to regulations, and wear protective glasses that meet regulations near the laser beam.

2. Operators must undergo training, be familiar with the structure and performance of the equipment, and master relevant knowledge of the operating system.

3. When the equipment is started, the operator shall not leave the post or entrust others to manage it without authorization. If it is necessary to leave, the operator should stop the machine or cut off the power switch.

4. Before determining whether the material can be irradiated or heated by laser, do not proceed with processing to avoid potential hazards such as smoke and steam generation.

5. Place the fire extinguisher within reach; Turn off the laser or shutter when not processing; Do not place paper, cloth, or other flammable materials near unprotected laser beams.

6. If any abnormalities are found during the processing, they should be immediately stopped and the fault should be promptly resolved or reported to the supervisor.

7. Keep the laser, bed, and surrounding areas clean, orderly, and free of oil stains. Workpieces, plates, and waste materials shall be stacked according to regulations.

8. When using gas cylinders, it is important to avoid damaging the welding wires to prevent leakage accidents. The use and transportation of gas cylinders should comply with gas cylinder regulatory regulations. Do not remove gas cylinders

Exposed to sunlight or close to heat sources. When opening the bottle valve, the operator must stand on the side of the bottle mouth.

9. Comply with high-voltage safety regulations during maintenance. Follow regulations and procedures every 40 hours of operation or weekly maintenance, every hour of operation or every six months.

10. After starting the machine, manually start the machine tool at low speed in the X and Y directions to check for any abnormalities.

11. After inputting a new workpiece program, it should be tested first and its operation should be checked.

12. When working, pay attention to the operation of the machine tool to avoid accidents caused by the cutting machine exceeding the effective travel range or collision between the two machines.