Laser cutting machine flashing alarm: emergency stop, height adjuster emergency stop, how to handle it?

Is the grounding of the laser cutting machine and computer correct.

Does the coordinate value at this moment exceed the value range limited by the laser cutting machine software.

Check if the size of the drawing you designed exceeds the machining range.

Check if the connecting wires between the motor shaft and the screw are loose. If loose, tighten the screws.

Alarm processing method for laser cutting machine: When the operating distance of the laser cutting machine exceeds the set distance, all motion axes of the laser cutting machine will be set to the jog state by default. If the manual direction key is manually pressed, the machine can be connected to the motion state at any time when it leaves the limit position. But when moving the workbench, it must be noted that the direction of movement of the workbench must be far from the limit. The engraving machine software alarm can clear the three axes in the coordinate settings.

How to clear three-axis zeroing? The method of 3dmax three-axis zeroing is as follows:

First, select the object, and then click the hierarchy button on the right editing panel, which is the icon for the three small squares below the top one.

Click on the axis, then click on the axis that only affects the axis to move the axis, and finally click on the alignment below to return to the center of the object.