Fault 1: Inaccurate cutting pattern size

Solution: Adjust software file settings. The pulse equivalent in the workbench is generally 32 per movement. According to different machines, 32 subtle adjustments can be added or reduced to achieve optimal cutting accuracy.

Fault 2: The direction represented by the x-axis, y-axis, and z-axis of the sound stuck during machine movement

Solution: Check if the bearing beads are broken in the synchronous wheel and need to be replaced. If the camera is used for automatic cutting, it may get stuck during the recognition process of the laser engraving machine, and the camera data signal line may break in the middle and need to be replaced.

Fault 3: How to cancel the y-axis servo alarm of the laser cutting machine if the machine does not move or the cutting pattern size changes irregularly.

Solution: Check if the driver and motor are powered on (the electric hand cannot be pushed), the green light of the drive is working normally, and if the motor track can be pushed, the motor shaft may break and the motor needs to be replaced.

The mechanical components of the laser blade have no contact with the workpiece, and will not scratch the surface of the workpiece during operation; Laser cutting speed is fast, the incision is smooth and flat, and generally does not require subsequent processing; The cutting Heat-affected zone is small, the plate deformation is small, and the cutting seam is narrow (0.1mm~0.3mm).

The precautions for operating a laser cutting machine are as follows:

1. Comply with the safety operating procedures of general cutting machines. Strictly follow the laser startup program to start the laser, adjust the light, and conduct experiments.

2. Operators must be familiar with cutting software, equipment structure and performance, and master relevant knowledge of operating systems.

3. Wear labor protective equipment according to regulations, and wear protective glasses that comply with regulations near the laser beam.

4. Do not process a certain material to ensure that it can be irradiated or cut by laser, in order to avoid the potential danger of smoke and steam generation.

5. When the equipment is started, the operator shall not resign or be in custody without authorization. If you need to leave, stop or cut off the power switch.

6. If any abnormalities are found during the processing, the machine should be immediately shut down, the faults should be promptly eliminated or reported to the supervisor.