1. Before starting the power supply, it is necessary to check whether the power supply is normal, whether the three-phase electricity is balanced, whether the power and signal wires are damaged, have poor contact, or even get bitten by mice. Laser cutting machine remote control.
2. Check the supporting equipment of the laser cutting machine, such as whether the air compressor is running normally, and whether the water in the air tank and filter is discharged. Customers who use nitrogen or oxygen should pay attention to whether the pipeline is leaking, especially when opening the gas, they should stand on the side of the air outlet to prevent excessive pressure and personal injury caused by the bursting of the air pipe.
3. Turn on the main power supply, open the software, check if the software alarms, manually check if the X/Y/Z/W axis is normal and returns to the original point (returns to the original point and calibration every time it starts).
4. Check if the copper nozzle and insulation ring are tightened and manually calibrate.
5. Press the blow button on the remote control to check if the high-pressure and low-pressure air are normal.
6. Turn on the laser (note that the high-power laser can only emit light after at least 30 minutes of self dehumidification) and check if the laser indicator light is normal. If there are any abnormalities, please contact the after-sales service engineer in a timely manner.
7. Before cutting, check whether the copper nozzle model corresponds to the plate, clean the protective lens, and check whether the process parameters are consistent with the plate. How to use the remote control of the laser cutting machine.
8. After the inspection is completed, locate the border and check if the red light is within the range of the sheet.
9. After starting the program, pay attention to the cutting situation at all times. If there are any abnormalities, eliminate the fault factors before continuing the cutting.
10. Finally, some customers drained the water tank before the holiday. Before starting, pay attention to adding pure or distilled water to the water tank, check whether the water pipe joint is locked, and whether the drainage valve is closed. When turning on the chiller, pay attention to observing the operation of the chiller, whether the water pipe is leaking, whether the pressure gauge values are normal, and whether the return pipe is flowing back (if there is no reflux: 1. Check whether the valves of each water pipe are open; 2. Check whether the water pipe is bent; 3. Check whether the water pump is empty, etc.). Finally, check if the temperature of the water tank is set correctly.
For northern customers, in order to avoid damage to the laser or other accessories due to water freezing, unnecessary losses can be reduced by adding antifreeze or maintaining workshop temperature.