1. No response during startup

▶ Check if the power fuse is burnt out: replace the fuse.

▶ Whether the power input is normal: Check the power input and make it normal.

▶ Is the main power switch damaged? Replace the main power switch.

2. No laser output or weak laser

▶ Whether the light path is offset: Carefully adjust the light path.

▶ Check if the reflector is contaminated or damaged: Clean or replace the reflector.

▶ Does the focal length of the device change? Readjust the focal length.

▶ Whether the focusing lens is contaminated: Clean the focusing lens.

▶ Is the cooling water quality or water temperature normal? Replace the clean cooling water to bring it to normal temperature.

▶ Whether the cooling water circulates: dredge the cooling water circuit.

▶ Whether the laser tube is damaged or aged: Replace the laser tube.

▶ Whether the laser power supply is powered on: Check the laser power supply circuit to ensure it is normal.

▶ Is the temperature of the entire machine too high: 1. Turn off the machine to let the temperature drop; 2. Strengthen ventilation and machine heat dissipation; 3. Adjust the ambient temperature.

▶ Is the laser power supply damaged? Replace the laser power supply.

3. Cutting/carving depth not ideal

▶ Whether the cutting/engraving processing parameters are normal: Set appropriate processing parameters.

▶ Is the laser power setting normal? Set the laser power correctly.

▶ Laser output weakens: see point 2.

4. Computer and device are not online

▶ Is the scanning switch on: Turn on the scanning switch.

▶ Whether the sports system is powered on: Check the power supply of the sports system and ensure it is normal.

▶ Is the DSP motion control card damaged? Replace the DSP motion control card.

▶ Is the signal wire loose? Reconnect the signal wire plug and secure it.

5. Processing size error or action error

▶ Whether the grounding of the entire machine and computer is normal: Ground the equipment and computer well.

▶ Is the signal wire normal? Replace the signal wire.

▶ Computer operating system malfunction or virus infection: Reinstall the operating system or antivirus.

▶ Check if the computer is functioning properly: Replace or handle the computer properly.

▶ Unstable power supply or interference signal: Install a voltage regulator or eliminate interference signals.

▶ Is the application software working properly? Reinstall the software and driver software for the motion control card.

▶ Are the processing parameters set correctly (such as layout): Reset the corresponding parameters

▶ Whether the processing program is written normally: Check the written processing program and modify it until it is normal.

6. The slider movement is not ideal

▶ Check if the trolley slide and slider are contaminated: Clean the slide and slider.

▶ Is the guide rail contaminated: Clean the guide rail and add lubricating oil.

▶ Is the transmission gear loose: Tighten the transmission gear

▶ Check if the transmission belt is loose: Adjust the belt tension.