When many enterprises use the fiber laser cutting machine, a slight carelessness in the operation process will cause great losses to the machine, especially the precise parts of the machine. When these small problems are ignored or cannot be solved well, the problems of the fiber laser cutting machine will be exposed after a long time of accumulated losses, and the failures will occur frequently. So how can we reduce the operation loss of the fiber laser cutting machine?

Before starting the fiber laser cutting machine, push the beam forward and backward by hand, and the trolley can be powered on only after it moves left and right without abnormal noise. When the laser cutting machine completes the work of the day, it should carefully clean up the waste and debris in the machine, so that the machine movement system can avoid being damaged by the operation of foreign objects.

Clean the moving parts of the laser cutting machine to keep the machine in good working condition. The specific methods are as follows:

1. Add a little lubricating oil to the screw, including the screw on the laser tube support and the first reflector, to facilitate the disassembly and assembly during maintenance. Note: Do not add lubricating oil to the timing belt, drag chain, air pipe, motor, sensor, lens and wire.

2. Do not place objects in the machine to avoid unnecessary damage to the machine.

3. Clean the dust and foreign matters on the metal oil tanker, metal shaft, sliding block and linear guide rail with cotton cloth, then add lubricating oil, and carry out idle reciprocating movement.

Optical fiber laser cutting machine is mainly used for metal cutting. The laser beam diameter of the laser cutting machine can reach 0.1 mm, and the cutting diameter on metal materials can reach about 0.2 mm. Therefore, the cutting pattern is very accurate. It not only improves the artistic taste and technical content of sheet metal processing, but also increases the profit margin. So when you operate the fiber laser cutting machine, you must cherish and standardize the operation, so that the equipment can better serve you.