The font of the laser marking machine will be required to be marked correctly without deviation, but when it comes to the marked word, it is slanted, and it is slanted to the right?

When debugging the reflector of the laser marking machine, it was found that the second reflector and the third reflector hit different points due to the distance of the laser head. If the laser head is far away from the second reflector and the point hit is in the center, the point hit at the distance will be lower. The far and near points are not completely consistent, which is too difficult to adjust, but the distance is basically small. The laser is also shot from the center point, Now the tricky thing is that the light is slanted and deflected to the right. What's the problem?

The adjusting lens of the laser marking machine can only be adjusted in one place, that is, the upper and lower screws on the side of the laser lens support frame. If they are slanted down, loosen the upper part or tighten the lower part. Here, it is necessary to note that the adjustment must be started from the first piece of lens coming out of the laser, and then adjust it to the laser head in turn. In addition, you said that there is a problem of beveling, because the laser is offset or the laser head is not vertical. The adjustment method is the same as the adjusting lens, There are also some adjusting screws on the laser head. You can try more. In addition, there is a focus lens that needs to be checked to see if it is placed correctly and if there is dirt on it. The lens can be wiped with alcohol.

If your laser marking machine is equipped with a laser locator, a cross object, which is placed at the place where the laser head enters the laser, it can accurately locate the accuracy of the laser into the laser head. If it is adjusted here, the laser output will not be wasted.

If it is still oblique, the solution is to rotate the laser head, rotate the laser head, test, and then try again. Adjust it to no deviation.