There are some problems that need to be noticed during the daily use of the optical fiber cutting machine. For example, this machine cannot be used under the conditions of lightning and thunder. If it is used under such adverse weather conditions, it may cause the machine to fail. It should also be noted that when cutting, the cutting materials should be kept dry and clean, and the cutting machine should be placed in a dry and clean environment. Otherwise, many disorderly things may be stacked together, which may affect the machine and equipment. When using this kind of machine and equipment, ensure that the level of cooling water is not lower than the minimum standard, otherwise, the insufficient cooling water may lead to excessive temperature and damage to the machine and equipment.
Fiber laser cutting machine
During the use of the optical fiber cutting machine, the relevant operators should do their own protection work, for example, wear protective goggles to operate, and must operate according to the product instructions. Dangerous operations are absolutely prohibited. The operators must carefully study the structure and operation methods of the machine before operating, and can only operate on the machine after passing the examination. During the operation of this machine, there is a maximum allowable temperature range. If the heat dissipation components inside the machine are damaged, the temperature of the machine will become higher and higher. If the maximum allowable temperature range is exceeded, the machine will be shut down or damaged. In addition, this kind of machine has requirements for the thickness of the material when cutting. If the thickness of the material has far exceeded the standard, the cutting efficiency will be greatly reduced. At this time, it can only replace the machine with higher power, or try to reduce the thickness of the material and then cut.
Some problems that should be noticed during the use of the optical fiber cutting machine are analyzed here. Of course, there are many other problems that need to be noticed. For example, this kind of machine equipment needs to use a special power supply. If the special power supply is not used, it may cause the voltage fluctuation in the machine to be unstable, and finally make the machine work unstable, which may make the cutting accuracy not meet the requirements, Or the cutting surface finish cannot meet the requirements. If a customer friend encounters some problems that cannot be solved when using this machine, he cannot disassemble the machine by himself at this time. Instead, he needs to call after-sales technicians to solve these problems.