The use effect of the optical fiber laser cutting machine has a great relationship with the debugging. With the rapid growth of the production and consumption of the metal industry in China, the plate processing technology has also developed rapidly, especially the advent of the laser cutting machine, which has brought unprecedented leap to the plate processing.

How to debug optical fiber laser cutting to make it faster and better?

In fact, machines, like people, need regular maintenance to maintain a good running state. In fact, there are ways to adjust the slow or bad cutting of the machine. Today, Longtai Laser will introduce several methods to improve the cutting effect and speed of the laser cutting machine.

one

Adjust the laser machine parameters and improve the cutting speed of the machine. Machine parameter setting is one of the main reasons that affect the cutting speed of the machine. In general, if the parameters are not adjusted properly, the cutting speed will not work. Parameters are just like the actions related to a series of actions such as driving, starting, accelerating, etc. If the parameters are not set properly, just like when the car is starting and you shift to a second gear to start, it will shake when starting. When adjusting this parameter, we should pay attention to the following points:

01

Initial speed: As the name implies, this setting is the starting speed of the machine, just like the starting speed of a car in the process of driving. Many customers have such a misconception that the greater the initial speed, the better, but in fact this is wrong. If the initial speed of the laser machine is set too high, the machine jitter will be very large.

02

Acceleration: acceleration means the speed of the fuel filler valve during driving. It is the time from the initial speed to the normal cutting of the machine. When the machine is cutting different patterns, it is a stop start process. If the acceleration setting is too low, the machine will cut slowly.

two

Adjust the machine assembly to improve the cutting effect of the machine.

01

Installation of guide rail: the guide rail shall be installed in parallel. If the installation is not parallel, the machine will have resistance when running. It will be stuck when walking, and there will be sawtooth when cutting. Therefore, the installation of the two guide rails in the Y direction can only be done with two parallel lines, and there should be no error between them.

02

The installation position of the cross beam and coupling is not good. When the machine cross beam and coupling are installed, the screw is not locked, or the lock is inclined. Therefore, in the daily use of the laser cutting machine, the matters needing attention must not be omitted, and the laser cutting machine should also be maintained regularly, so that the equipment can run longer.