Optical fiber metal laser cutting machine is a commonly used processing equipment in the modern sheet metal industry. In the process of processing, sometimes some troublesome faults occur, such as abnormal reset of optical fiber cutting machine. The equipment cannot be reset correctly, which is related to the accuracy of the next processing. How to adjust the abnormal reset is a concern of every customer. How can we debug the reset accuracy of the laser machine?

As the use of optical fiber laser cutting machine is widely concerned, it is not only required to use it in the technical production process, but also needs to understand that the metal laser cutting machine occasionally has the problem of being engraved and abnormal initialization. Here, data correction is required to solve the problem.

The initialization of the optical fiber metal laser cutting machine is incorrect, and the data is sent (correct); Running sequence inversion (reinput); Static interference (check whether the ground line falls off); Clear the edge dislocation, disable the shutdown, and check that the software parameters are set correctly (reset); Computer system error reinstallation; Check whether the left belt is consistent or too loose; These may cause abnormal device reset.

To sum up, the reasons for the abnormal reset of the optical fiber metal laser cutting machine include:

1、 The movement direction of the x axis and y axis is wrong, and they collide with the side end. For this phenomenon, you must check whether the device motherboard parameters are correct, and check whether the motherboard parameter settings are correct.

2、 Check whether the control panel of the optical fiber laser cutting machine displays abnormally. After the x-axis and y-axis are fixed, you can try to pull the sensor terminal of the motherboard to see whether the machine acts. If there is any abnormality, you will consider replacing the sensor.

3、 After attempting to reset the beam of the optical fiber cutting machine to normal, reset and fix the X axis of the laser cutting machine. It may be that the motor wire or motor shaft is broken. In this case, the motor wire or small motor shaft should be replaced.

4、 When the reset is in the correct direction, but the top x-axis or y-axis cannot be stopped (see the motherboard parameters first), if the motherboard parameters are correct, check whether the motherboard or sensor is damaged. If there is an exception that needs to be replaced, use the troubleshooting method to find the root cause of the problem.