How to keep the laser cutting machine in good condition? How to maintain the laser cutting machine? The following points may help you.
1. How to maintain the laser cutting machine?
The cooling system must be grounded. Clean the water tank and water circuit regularly. The temperature control point of the cooling temperature control water tank must be appropriate, otherwise the laser tube may be damaged. Condensation may occur, and even worse, the laser power will be reduced. Therefore, the service life will be greatly shortened. At the same time, it sometimes fails to work properly.
Correctly install the laser pipe fulcrum of the laser cutting machine. The fulcrum shall be 1/4 of the total length of the laser tube. Otherwise, the spot pattern of the laser tube will be damaged. Sometimes the light spot will become several points in a period of time, which will reduce the laser power.
2. Keep the laser cutting machine in good condition
Clean water protection devices should be checked frequently.
How to maintain the laser cutting machine?
3. Regularly check and clean the dust collection device
Fan ducts should be cleaned frequently. Otherwise, a large amount of smoke and dust will not be discharged. This will contaminate the lens and the laser tube. This makes mechanical and electronic parts easy to oxidize and leads to poor contact.
4. Inspection of focusing mirror and reflector
After working for a period of time, the frame will become hot. The lens surface will change color and rust. When peeling and cracking occurs, we must replace it. In particular, many customers like to use air pumps and air compressors, and the focusing lens is easy to cause water accumulation on the surface. Therefore, it is necessary to regularly ensure the cleanliness and quality of the lenses in the optical system.
5. Ensure that the machine has a good working environment.
The working environment of the laser cutting machine should not be too poor. Excessive dust and serious air pollution. This will cause damage to the machine and the failure rate will continue to increase. Electrical accessories in wet environments are prone to errors.
6. The working current of the laser tube must be reasonable.
It cannot work at full power for a long time. We must use the laser properly and maintain the laser. The optical system should be cleaned regularly, otherwise the laser tube will age and break prematurely. During operation, the power of the laser equipment should be adjusted to 50-60% of the total power. Then adjust the working speed according to the material, which is the best working state of the laser tube.