1. Please observe the general operating specifications of the optical fiber laser cutting machine. Start the laser according to the start-up procedure of the operating specification.
2. Operators must be trained. Familiar with equipment structure, performance and operating system knowledge of optical fiber laser cutting machine.
3. Wear protective equipment and laser protective glasses as required.
4. Before knowing whether the materials can be irradiated or heated by laser, please do not handle them to avoid the potential danger of smoke or steam.
5. The operator shall not leave when the equipment is running, and must stop the operation when leaving.
6. Put the fire extinguisher within your reach. When the machine is not working, please turn off the laser source or turn off the machine. Do not place paper, cloth or other flammable materials near the laser beam.
7. Shut down the machine in time in case of any abnormality during handling,
8. Keep the machine in order. Stack workpieces, plates and scraps as required.
9. Follow standard procedures when servicing the machine. Maintain the machine every 40 hours or every week, every 1000 hours or every six months according to regulations and procedures.
10. Before the first use, check the X and Y directions manually at low speed to confirm whether there is any abnormal condition.
11. After downloading the new workpiece program to the machine, run it first instead of cutting, and then check whether it can be used normally.
12. Observe the working condition of the machine during operation. This can avoid accidents caused by cutting machine exceeding the specified travel range.
Pay attention to the operation and maintenance of the optical fiber laser cutting machine. In this way, we can extend the service life of the equipment. At the same time, save costs and increase profits.